You ll know this by seeing water discharging from the softener drain and by hearing water running through the softener continuously for more than three hours.
Water softener cycles too often.
If your water softener is running regeneration cycles regularly but the salt levels in your mineral tank are not diminishing it is very likely that a crust known as a salt bridge has formed in your brine tank.
How does a water softener know when to regenerate.
In most cases a water softener may cause low water pressure issues in the following cases.
If you only need a 30 second answer here it is.
The system is too small.
Once the basket has cracked and the resin has escaped the tank it can be a rather expensive procedure to have a professional come out and replace the basket and re bed the resin.
Ultra efficient softeners can regenerate daily.
Often one cycling a week will be sufficient for a family of four.
A fleck 5600 water softener goes through a regeneration cycle every 3 15 days in ct.
First the control valve is set incorrectly.
This often happens due to water pressure in the home being too high and the water softening resin continually being pressed up against the water softeners basket.
Your owner s manual should provide some insight into its schedule if it regenerates based on demand.
When sizing your water softener check the inlet pressure it can handle as well as the output pressure it promises.
The service position this is not part of the regeneration cycle.
Demand regeneration is a setting where the valve keeps track of water usage and sends the softener into regeneration mode after a pre determined amount of water has been processed through the softener.
It s rare that you ll go a week without a cycle but it does happen.
This cycle is repeated approximately weekly depending on water usage allowing your home to have consistently soft water.
And the second reason is the salt bridging or salt mushing.
The softening resin in the water softener is now clean and ready to soften water again.
Click to enlarge any image.
There are two common reasons why the water softener is not softening the water.
An improper sizing of the system can cause low water pressure.
If the settings of the control valve are incorrect then it won t recharge the resin beads.
Concerns about water softeners with too much backwash flow and.
Salt bridges prevent the pellets of salt from dissolving in the water used to regenerate the water softener s resin beads.
Water softener regeneration cycle time too long if your water softener is running in regen mode continuously something is drastically wrong.
Water softener above 121 mg litre you may want to consider a water softener.
