Water Softener Valve Position

Follow them to lead you to the bypass valve.

Water softener valve position.

Normally the valves are in a horizontal position when the. These are the inlet and outlet hoses for water moving through the softener. Check the valves positions. The rotor position switch tells the timer what position the rotor is in so the timer knows when to start the motor that turns the valve rotor through cycles.

This is usually behind the water softener s control box. 7 set the bypass valve to the bypass position and turn on the water to run through the softener for a few minutes to flush out sediment and expel air in the pipes. Locate the water softener then look for 2 large hoses running out of it normally either out of the side or the back. One on the inlet one on the outlet and one on the main line.

Put your conditioner into the backwash stage and set the bypass valve to the service position. Turn the water supply valve completely on when a steady stream of water appears at the drain. Also open the valves to the water heater and restore its power and or turn the gas valve back on and relight the pilot if necessary see how to relight a gas water heater. The bypass valves are located where the water softener connects to the water pipes.

We explain what is the bypass valve on a water softener where to find it and we describe when how to position the valve to take the water softener conditioner in or out of service. To put in a water softener open the water supply valve to the 1 4 position to let oxygen run from the drain line. Water softener bypass valve operation repair guide. If the position switch breaks the motor runs constantly.

This diy repair guide explains how to replace the rotor position switch in a water softener.