Water Heater Relief Valve Discharge Pipe

This pipe is responsible for routing hot water released from the tpr to a proper discharge location.

Water heater relief valve discharge pipe.

The discharge piping serving a pressure relief valve temperature relief valve or combination valve shall. The valve should be connected to a discharge pipe also called a drain line that runs down the length of the water heater tank. Instead it is attached with a discharge pipe link with hot water heater. Temperature pressure relief valve discharge tubes drain lines their piping.

If the temperature in the water heater reaches 210 or the pressure reaches 150 psi the relief valve will open reducing the pressure or releasing heated water to be replaced with cold water. If the pressure in the tank exceeds 150 psi or the temperature exceeds 210 degrees fahrenheit the tpr valve opens to release the pressure. Heating element pressure relief valve rheem water heater accessories gas valve water heater accessories treater smokers hotwire. How doers get more done.

This is a very simple video on how to replace add a discharge pipe on a water heater. The purpose of this drain line is to discharge potentially hot scalding water to a safe location so that a bystander is not scalded. Not be smaller than the diameter of the outlet of the valve served and shall discharge full size to the air gap. This temperature pressure relief valve is not directly attach with the hot water pressure heater.

The temperature pressure relief valve or tpr valve on any heated appliance that contains water such as a heating boiler hot water tank water heater water cylinder must have a drain line or discharge tube properly installed routed and made of proper materials. Verify the proper valve is installed the tprv on a water heater is set to discharge at 150 psi or 210 fahrenheit. 1 the discharge pipe cannot be directly connected to the home s plumbing drainage system but an air gap located in the same room as the water heater can used to connect to the drainage system. You may have an issues with the hot water coming out of overflow pipe.

Not be directly connected to the drainage system. Discharge through an air gap located in the same room as the water heater. Just image the power that can be generated when the water starts to boil inside the tank. Building codes require temperature pressure relief tpr valves with discharge pipes on all new water heater installations.

Scalding water and steam escape the tank through the valve and tube to relieve the pressure. This is to prevent a potentially catastrophic failure. Yes part of the video i have the camera between my teeth lol you ca.